OpenBCM V1.08-5-g2f4a (Linux)

Packet Radio Mailbox

IZ3LSV

[San Dona' di P. JN]

 Login: GUEST





  
:::::::::
:: TNC ::
:::::::::
(only sysop, only DOS, option _TNC in config.h)
Syntax: TNC <pcflex command>

You can configure PC/Flexnet with this command (change parameters). Not all
PC/Flexnet commands can be used. If you don't run node (flexdigi) the
changed parameters are not saved, this means they are only used until next
reboot. So you should better use a batch file before starting BBS and
edit FSET lines there. While BBS is normally connected via wire to node
flexnet parameters have only minor importance with exception of baud rate.
If running flexdigi, you should better use direct connect to setup
parameters.

See also HELP TNC TRACE

 29.12.2024 18:07:10lGo back Go up