| |
VK7AX > SSTV 27.11.08 05:05l 189 Lines 5606 Bytes #999 (0) @ WW
BID : VK7AX-2711MM
Read: GUEST
Subj: [MM-SSTV] Digest Number 1896
Path: IZ3LSV<IK2XDE<DB0RES<DK0WUE<7M3TJZ<CX2SA<VK7AX
Sent: 081127/0401Z @:VK7AX.#ULV.TAS.AUS.OC #:57190 [Ulverstone] FBB7.00g $:VK7A
From: VK7AX@VK7AX.#ULV.TAS.AUS.OC
To : SSTV@WW
There are 3 messages in this issue.
Topics in this digest:
1a. Re: Beginner needs a little help
From: ve3wej gmail
1b. Re: Beginner needs a little help
From: father christmas
2. Pages updated
From: Paul Young
Messages
___________________________________________________________________
1a. Re: Beginner needs a little help
Posted by: "ve3wej gmail" ve3wej(AT)gmail.com ve3wej
Date: Fri Nov 14, 2008 12:18 pm ((PST))
just a note, if that receiver has filters, dont be narrower than 2.5,
or it might be cutting off some of the data as well
VE3WEJ
Dave Garber
10-X # 23465
echolink # 52852
irlp node 2202
email ve3wej(AT)rac.ca
----- Original Message -----
From: "Barry" <Barry(AT)india-whisky.org.uk>
To: <MM-SSTV(AT)yahoogroups.com>
Sent: Friday, November 14, 2008 8:07 AM
Subject: RE: [MM-SSTV] Re: Beginner needs a little help
> >
> >
>>> >> > hi sam have you got one yet its on 14.230.0 usb listen on ssb
>> >>
>> >> My frequency counter was used to put me on 14.230 and I didn't drift
>> >> too much. And there I left the program running without making changes
>> >> to the settings... and listening as I did some web browsing.
>> >>
>> >> Lo and behold after some time (maybe an hour) I heard what seemed to
>> >> be synch pulses and data fading in slowly, and back out, then there
>> >> was this very short period where signal strength was high and
>> >> background noise level moderate, and the program locked.
>> >>
>> >> I got 1/6th of a screen in Scottie1 mode with a clearly identifiable
>> >> callsign (out of Honduras).
>> >>
>> >> Now we are getting somewhere.
>> >>
>> >> My issue is not the radio, it's the reception / band conditions,
>> >> maybe my antenna...
>> >>
>> >> This is a much more challenging hunt than PSK31.
> >
> > Hi, the transmission may not be spot on 14.230, you would normally need to
> > fine tune into the signal.
> > 73
> > Barry M0IOW
Messages in this topic (14)
___________________________________________________________________
1b. Re: Beginner needs a little help
Posted by: "father christmas" kennetcanal(AT)yahoo.com kennetcanal
Date: Fri Nov 14, 2008 9:22 pm ((PST))
hi also on 144.500 fm
--- On Thu, 11/13/08, ve3wej gmail <ve3wej(AT)gmail.com> wrote:
From: ve3wej gmail <ve3wej(AT)gmail.com>
Subject: Re: [MM-SSTV] Beginner needs a little help
To: MM-SSTV(AT)yahoogroups.com
Date: Thursday, November 13, 2008, 8:30 PM
also 3845, 7176??, 14227, 21340, 28680 when band conditions allow
VE3WEJ
Dave Garber
10-X # 23465
echolink # 52852
irlp node 2202
email ve3wej(AT)rac.ca
----- Original Message -----
From: "kevin knights" <knightskevin(AT) yahoo.co. uk>
To: <MM-SSTV(AT)yahoogroups .com>
Sent: Thursday, November 13, 2008 1:46 PM
Subject: Re: [MM-SSTV] Beginner needs a little help
> > hi try 14.230.0 mhz ± this is 20 meters calling for sstv
> >
> > sernstfortin <sernstfortin(AT) yahoo.com> wrote: Hello, very new to
> > MMSSTV.
> >
> > I think I need a little help. I've got a Realistic DX-160 connected via
> > isolation xformer and voltage divider circuit to the Line-In on a USB
> > iMic interface and laptop.
> >
> > I can decode CW with CwGet and PSK31 with DigiPan programs using the
> > interface without a problem.
> >
> > Using MMSSTV, I'm a bit lost still, even after reading over the help
> > file that is in the FILES section "MMSSTV_with_ index.doc"
> >
> > I did calibrate the clock using the adjust procedure: "Soundcard
> > calibration. txt" using WWV with no issue.
> >
> > #1. Perhaps one thing which would be helpful is if someone would kindly
> > upload an SSTV audio capture so that I know for sure I'm audibly
> > hunting the proper signal...
> >
> > #2. With a DX-160, I am using a frequency counter to estimate my analog
> > tuning location in the band. I know I should be in SSB Mode. Do I have
> > to adjust the frequency recommended based on USB or LSB?
> >
> > #3. What would be the most likely frequency in N.A. (Georgia) to go
> > after (day vs. night).
> >
> > #4. If I put most of the signal content between 1500 and 2300Hz via BFO
> > adjustment, will the program accomodate a little drift?
> >
> > No matter what I do thus far, I cannot seem to lock onto the synch and
> > have not successfully decoded an image yet.
> >
> > Thanks for anyone's help.
Messages in this topic (14)
________________________________________________________________________
________________________________________________________________________
2. Pages updated
Posted by: "Paul Young" paul(AT)g0hwc.com paulyoung004
Date: Fri Nov 14, 2008 9:22 pm ((PST))
Hi all,
Over the last few days I have been updating cam pages on my site. If
your site is listed with any errors please let me know.
I have now added a page for Digital SSTV sites, If you know of and
sites that I don't have listed please let me know...
Paul G0HWC
http://www.g0hwc.com
SSTV Ring: http://g0hwc.com/sstv_atv_ring_members.html
World Cams: http://g0hwc.com/world_wide_live_sstv.html
Digital: http://g0hwc.com/digital_sstv_world.html
You are welcome to link to any of the above.
Messages in this topic (1)
------------------------------------------------------------------
******************************************************************
ABOVE IS A CROSS POST TO THE PACKET RADIO NETWORK IN AN EFFORT TO
PROMOTE FURTHER INTEREST IN SLOW SCAN TELEVISION AND PACKET RADIO
Courtesy Tony VK7AX VK7AX(AT)VK7AX.#ULV.TAS.AUS.OC
******************************************************************
Read previous mail | Read next mail
| |
